Page 1 of 2

New Chart Indicator: _TRO_OHMLC

Posted: Fri Jul 14, 2006 2:50 pm
by TheRumpledOne


Chart indicator _TRO_OHMLC draws horizontal lines at the open, high, midpoint, low and close of previous candle.

Of course, those are INPUTS so you can change them.

Colors are inputs too.

ELD attached.

Posted: Sat Jul 15, 2006 1:24 pm
by TheRumpledOne
You can also use this indicator to plot fib levels:





When the inputs are under user control, you can make an indicator do just about anything you want it to.

Posted: Mon Jul 17, 2006 8:24 am
by jtrade
Very nice indeed, TRO - K.I.S.S.

Many thanks,

J.

Problem with Mddle Indicaotr

Posted: Tue Jul 25, 2006 5:00 am
by jstockman
Dear TRO,

Any thoughts on why your indicator plots on the of the first bar of the
chart rather than the previous bar before last bar of chart?

Regards,

Jimmyj

Posted: Wed Jul 26, 2006 12:34 am
by TheRumpledOne
Cause that's where I want it to plot! LOL!!

I want the previous bar's data on the current bar so I can see when the "targets" are hit.

Posted: Wed Jul 26, 2006 11:30 pm
by jstockman
TRO

My screen shot must not have got attached.

I have data back to 1/3/06 with the indicator on it. My current bar was 07/25/2006. The indicator is not seen on 07/24/2006 but is seen clear back at 01/03/2006. I can't seem to make it apprear on the the prviouse day.

Any thoughts?

Jimmyj

Posted: Mon Aug 21, 2006 10:46 pm
by aasefi
Hello TRO
How do you read this indicator?

Posted: Mon Aug 21, 2006 11:35 pm
by TheRumpledOne
You read it however you set it up.

It is just a universal tool to plot whatever input levels you give it.

Posted: Thu Jun 25, 2009 5:46 pm
by werner
hi tro,
i have instal the eld but i see no lines in the chart.

Posted: Thu Jun 25, 2009 5:52 pm
by werner
lol ,if i make a compleet new chart then i can see them in the chart, how is that posible?